Advice on Future Setup with HTPC

[Babymonster45]

I am looking into setting up a HyperHDR/HyperSPI system with parallel multi-segments, and I am wondering how much RAM the software stack utilizes on a Raspberry Pi. Is 2 GB fine, or should I go with 4 GB?

I am also curious if I can install HyperHDR on my home theater pc and directly capture my screen from that to control the lights with a HyperSPI setup. The Pi and the PC would both be connected to Ethernet, so minimal latency. I would like to just plug the PC directly into my display without any passthrough devices.

[awawa-dev]

Hi
If only HyperHDR runs on the RPi4 then even 1GB is enough.

The Pi and the PC would both be connected to Ethernet, so minimal latency.

It's possible to synchronize two HyperHDR instances: https://github.com/awawa-dev/HyperHDR/wiki/Quick-start#synchronization-between-different-hyperhdr-devices

Or if your PC is the only video source then skip RPi comtpletly and use HyperSerialPico.

[Babymonster45]

I think HyperSerialPico would fit my setup better, and if I feel the need to use other devices I could always upgrade to HyperSPI. Huge help, thank you.