S100101, Board V2B, What am i doing wrong?

[robinvandienst]

Hello, First off all thank you for creating this wonderfull project.

I ordered all the parts and soldered the board, then did the steps to flash it.

On usb power as well when connected to the pump i'm getting the UI.

The display doesn't turn on, and i cannot control. When i change the pump type the only thing i get is al really short sort of beep.

Can it be that i need an other pinout or something? I also tried the Lazy Setup (i thought, give it a try..)

Original Connection (Without board):

Connection Board to Pump:

Connection Board to Display:

Board:

Pump Type Plate:

[metaljay]

Firstly you don’t need cable at both points, just H1B and H2B.

have you selected your board revision on HWconfig as v2b?
equally the 10k resistor, is that the right one as it looks the same as the other resistors from here

[robinvandienst]

Thank you for responding. i only soldered the "extra" wires for testing. i did select v2b in de HWconfig. The resistor is a 10k, may be difficult to see on the pictures but it's different from the others.