Label Gutter removal

[alextrical]

I'm looking to setup a label on 6, 9, 12mm Tape, however the gutter forced on the label is not benificial here, as the priner is thermal, it is able to print on the entire surface.

Is it possible to remove the top and bottom gutter of a label in the Label profile?

[alextrical]

So the gutter is pushing the available space inwards quite a bit for a 12mm tape, and presumably will make a 6mm tape almost impossible to use.

Picture of the label when it is printed. 2/3 of the label is wasted to the gutter created in the Part-DB label creation

[mkne]

I'm not sure if this is still relevant for you but I found that you can add the following additional CSS code in the label profile:

@page {
    margin: 1px 1px;
}

I'm still trying to figure out how I can ensure that the datamatrix code is squared. In the screenshot above it looks relatively OK but for other dimensions it's squeezed and streched.